curtsnow
0 0

Helix 8 Installation

207968 переглядів
30 зображень — 4 років тому
Various pics of my Humminbird Helix Installation, from start to finish.
20200310_165002.jpg
Transducer with shield installed
20200310_165049.jpg
Transducer with shield installed
20200310_165041.jpg
Transducer with shield installed
20200308_154234.jpg
Installation of the choke to prevent trolling motor interference with the Helix
20200308_145100.jpg
The completed fuse panel installation
20200308_145010.jpg
Power leads for the Helix are now connected.
20200308_143534.jpg
Power leads connected to the panel
20200308_135410.jpg
The fuse panel is now mounted
20200308_134354.jpg
Plastic spacer
20200308_132756.jpg
Where my sub-panel will be mounted
20200302_190743.jpg
Trying different angles
20200302_190626.jpg
Testing the power
20200302_182622.jpg
Installation complete
20200302_182618.jpg
Unit installation on the bow is finished
20191228_162831.jpg
Placing the mounting bracket
20200228_145328.jpg
The Ethernet cable is also now pulled from the console to the bow!
20200228_140748.jpg
The 12 gauge wire is now at the bow!
20200228_140541.jpg
CAT5 wire stashed in the bow.
20200228_135729.jpg
A piece of CAT5 wire that I had left in the hull from another previous pull.
20200228_135134.jpg
Pulled through to the console area!
20200228_133301.jpg
This end of the rope was stowed under my console.
20200228_133137.jpg
Taped up and ready to pull!
20200228_132838.jpg
Rope left in the hull from my last previous wire pull.
20200228_132752.jpg
I used this nylon rope to pull the wires through my hull.